Description The kit contains everything needed to perform minor repairs on marble and granite. The kit also allows those who are not expert in manual work to glue broken marbles, repair chips or small lesions on natural stones. You can also paste ceramic, stoneware, terracotta, cement and so on. WORKS: on any type of stone How to use In the case of stones with polished surface you may want to sand the area of the break with 120 abrasive , to remove the gloss finish in a small neighborhood. So you limit the area to be repaired with transparent PVC film, fixing them with adhesive paper and leaving free only the minimum area for work. It is prepared following the glue pouring into the cup the contents of the tubes single dose A B. It blends well using the spatula and distributes the glue inside of the break in sufficient quantity without excess. The work must be done in 15-20 minutes to work with glue sufficiently fluid. Just spread the glue, join the two sides, squeezing good contact to make invisible the fracture line. To end the bonding phase is applied a strip of PVC on top of the glue coming out from the break, pressing lightly to level the resin. After 24 hours, peel the strip from the hardened glue and sand with coarse-grained sandpaper to reduce the layer of adhesive to a thickness almost imperceptible, but not eliminating it entirely. Then use the yellow diamond plate and wet sanding the surface, removing any trace of resin on the surface and escaping any scratches left by the sandpaper. Where it works It works on all natural stone: marble, travertine, limestone, granite and on the compounds of factory as agglomarmi and stoneware. Package Contents The package contains the following items: • n. 1 mini diamond plate size 4.5 x4x0.3 cm. 100 grit, yellow • n. 2 pieces sandpaper velcro backed 120 grit • n. 4 pieces sandpaper velcro backed 60 grit • n. 1 pad velcro backed hook • n. 2 2 single dose tubes of resin A B • n. 2 cups with spatula • n. 1 pair protective gloves • strips transparent PVC film
