WMA UV Spec Ceramic is an external, trafficable, non-slip waterproofing membrane. Tested in accordance with AS1580.403.2 UV SPEC Ceramic is suitable for Occasional Service vehicle traffic and pedestrian traffic. FEATURES AND BENEFITS Tested in accordance with AS4586:2013 Appendix achieves a P5 classification. Certified class III elasticised water-based polyurethane membrane Compliant to AS 4858:2004 – Internal Wet Areas Waterproofing Compliant to AS 4654.1– Waterproofing Membranes for External Above Ground Use Trafficable UV Resistant Environmentally friendly APPLICATIONS External wet areas, balconies, terraces, decks & podiums, garages and walkways Roof top areas & roofs Surfaces requiring a strong trafficable waterproofing membrane USAGE / PURPOSE: UV SPEC Ceramic has been designed as an effective membrane for use within the building industry. For external covered areas such as balconies, podiums, or decks. & External uncovered areas such as walkways, driveways, and rooftops. Surfaces suitable for application within these areas such as; Concrete – FC Sheeting – Masonry – metal – cement render – plasterboard – particle board, All substrates must be clear of dirt, dust and contaminants must be made good and suitably primed. SURFACE PREPARATION – COVERAGE The stated Coverage of this membrane is dependent on substrate conditions and preparation. Approximately 0.85mm per m² on walls and 1.7mm for walls to per m² WFT for a dual coat system, Floors – 1.00 dry film thickness(approx. 9m² per drum) Walls – 0.5mm dry film thickness (approx. 18m² per drum) Note: Coverage figures are dependent on substrates condition. SURFACE PREPARATION PERFORMANCE DATA @23º C& 55% RH Tac touch after 2 hours Allow 6 -12 hours between coats Allow 36 hours drying time prior to tiling Always allow longer drying times in cooler or damp conditions. Flood Test 4 days curing Drying & curing is affected by porosity of surface, ventilation, weather. Application techniques. Curing time and drying are given as a guide. SAFETY AND PRECAUTIONS UV SPEC Ceramic s a water-based product; however, avoid contact with skin and eyes. If poisoning occurs, contact a doctor immediately or the poison information center. Use of gloves and eye protection is always recommended. WARRANTY WMA products are manufactured very rigid quality standards and guarantees the performance of UV SPEC Ceramic when the following applications are followed. Applied to adequately prepared and structurally sound surfaces All tiling installed in accordance with AS3958 All waterproofing membrane installed in accordance with AS4654 and AS3740 All relevant requirements of NCC WMA TDS or other written instructions WMA Will warrant its products for 10 years from time of application. If any product that have been applied in accordance with its specific data sheet or with WMA written instructions that have been proven faulty or defective, WMA will replace product free of charge and cover labor of original installation.
