Description INSTRUCTIONS Parts to be bonded must be transparent. E.g. Glass or clear plastic. This adhesive works best on well matched pieces. It is not recommended for gap-filling or for coating. Make sure surfaces are clean, dry and free from oil and grease. Work out of direct sunlight or the adhesive will cure before the bond has been made. Apply adhesive to one surface. Bring the two surfaces together and then expose to UV light or direct sunlight. Make sure the pieces are held together well as a slight shift will be permanently bonded in that position. The parts will be bonded in approximately 5-10 seconds. For maximum strength, leave in the UV light / sunlight for 5 minutes. Excess adhesive that is squeezed out from between the surfaces and exposed to the air will also cure but will have a slightly sticky surface. This excess can be removed with a blade alternatively the sticky surface can be removed with acetone (nail polish remover). Note: Acetone can cause some clear plastics to become “cloudy” so do this with care. STORAGE Store in a cool dark place. If refrigerated allow adhesive to reach room temperature before using. SOME SUGGESTED REPAIRS: Trophies. Glass ornaments. Parts to be bonded must be transparent. E.g. Glass or clear plastic. This adhesive works best on well matched pieces. It is not recommended for gap-filling or for coating. It is not recommended for gap-filling or for coating.
